Power interface & programming

Contactors, relays, delay timers, latching relays, energymeters: a whole range of devices to control installations for more energy efficiency.

Modular contactors

The choice of a contactor depends upon a number of parameters like:
  • the nature of the supply
  • the power it is switching
  • the characteristics of the load
  • the control voltage required
  • the number of operations

Contactors from 25 to 63A
For the remote switching and control of power circuits.

Low noise contactors
Are recommanded in areas of habitation zones where a low noise functionning is requested.

Override contactors
Allows:
- permanent ON
- permanent OFF

The use of head dissipation inserts (LZ060) between all contactors installed or between contactors and adjacent devices is recommended.

Delay timers

To provide all types of automatic control i. e. lighting, ventilation, watering, machine pre-heating, automatic door and visual audible indication, cycle control, etc.

Latching relays

For the control of lighting circuits in private buildings, small industry buildings and administration buildings. Latching relays operate when impulsed by a signal voltage.

Energymeters

To measure the active energy consumed by an installation. They allow to have under control the real cost of an installation and to divide the consumption between the different appliances.

Current transformers

Current transformers are used to feed analogue and digital ammeters. As well as kWh meters.

Roller shutter and motorized blind controls

For a general, individual and group control.

EL001 to control shutter or blind and disposed and auto/manual input to control independently or general mode.

EL003 for group control (with EL001 connected on the right side).

EL004 allows the power supply continuity and control between 2 rows in electrical boards.
Registration